Zipper Tips | An easy trick to fix a stuck zipper on your jacket or pants: All you need is a pencil

Simple trick to fix a stuck zipper on your jacket or pants: All you need is a pencilblinds

Zippers allow us to put on and take off clothes easily and quickly without using buttons. We find them not only in the clothes we wear, but also in bags, shoes, suitcases, and more.

Sometimes zippers can break or get stuck. In this article, we’ll go over some simple and practical tips to repair a damaged zipper without having to replace it or call a tailor.

A stuck zipper is the most common situation, and there are some helpful tips to make it work perfectly.

Cursor stuck in fabric

The zipper may get stuck due to the fabric getting caught on the slider. Use tweezers to grasp the fabric and gently pull it away from the slide.

Five tips for roasting chestnuts in the oven at home to perfection

How to Lubricate a Zipper

If we find that the zipper is completely stuck and cannot be released, we can use lubricant, such as pencil graphite, which is a good unlocking agent. Just slide the tip of the pencil along the zipper a few times, where the slider catches. Slide the zipper up and down until it slides completely.

If we encounter a situation where the zipper always opens, there is an easy way to fix it.

Open the zipper completely and observe carefully whether there are any crooked teeth. If so, use pliers to straighten the dent, being careful not to break it.

Best Tips for Cleaning, Cooking and Preserving Mushrooms

independent hinge

If you close the hinge and find that the sides are open under the slide, this is because the slide is loose and is exerting very little pressure on the teeth. Just use a nutcracker or tongs to gently squeeze from both sides.

How to replace the slider

Equip yourself with the same sliders and retainers that need to be replaced. Use pliers to pry up the latch at the end of the hinge. Continue sliding the slider between the two rows of teeth until engagement occurs. Use pliers to crush the slider and slide it up and down to check if it is working properly.